16075 Highway 13 S., Prior Lake, Minnesota 55372 Phone: (952) 440-8778 or FAX (952) 440-8776
PARTS HOMEPAGE VEHICLES
FOR SALE E-MAIL
JOHN 
Battery Box Lid
We have both early and late type lids available. Early lid shown.
We added the thumbscrews for a more accurate restoration.
The screws have not been available for years.
Early or Late Lid - $80.00
Lid Seal - $12.00
Thumbscrews - $3.00 each
Battery Retainers
Get these always-missing parts replaced with a MWM repro.
As good as OEM. Specify 38 or A1.
Retainers - $24.00 each.
J-Bolts - $7.00 each.
Battery Box Bottom
MWM reproduction part.
Replace your rusted box bottom with an accurate, quality part.
Proudly produced by us in the USA.
$39.00
Jeep Battery Tray
MWM has invested in the tooling to accurately reproduce this much needed
part.
Now available, an M38 and M38 A1 style tray for your Jeep.
Ours, pictured here, looks like NOS!
Price - $70.00 each
Brake Master Cylinder Heat Shield
Accurately reproduced by MWM for proper fit and function.
M38 shown, A1 also available.
$40.00
M-Series Full Red Lens
Finally available again, the Gama Goat red lens.
These will fit all the Early M-Series round taillight housings. Safer than
the original small red lens, but still Military.
$24.00 each.
Taillight Bracket
Correct for the M38 or 38 A1. A weld-in part that was not previously
available.
Commonly rusted out or damaged, now you can easily fix the problem.
$14.00 each.
Voltmeter - M-Series
Correct for any M-series truck or jeep. Correct Douglas metal shell for
the early trucks.
This can replace the Ammeter with a 5-wire spider harness, (aslo in stock).
If you are running a Solid State voltage regulator, you must use this gauge.
$80.00 each.
M38 A1 Floor Pans
And now the newly completed M38 A1 floor pans with the same attention to
detail as the M38 ones above.
Repair your original body tub with these identical replacements.
Need a fuel tank sump? We have those also.
Left & Right Floor Pan - $130.00 each
Fuel Tank Sump (not shown) - $125.00
M38 A1 Channel Kit
Finally, a complete and accurately formed hat channel kit. These are almost
always rusted out!
Tapered ends, offsets for proper fit, pre-prunched plug weld holes ... all
to make your repair easier and look like an original.
Five-piece Kit - $140.00
Need just one piece? Call us and we can help.
M38A1 Shock Absorbers
New reproduction A1 shock absorbers. Correct part number and manufacturer
stamping.
Stone guard is also on the rears. Bushings included. Never before available.
$175.00/set of 4.
Wing Drain Cover Kit
We made these correctly for all M38's and 38A1's. The screws have not
been around for years.
All items available separately also.
Kit Price (2 Wing Drains & 2 Screws) - $20.00
1 Wing Drain with 1 Seal & 2 Rivets - 8.00
Screws - $3.00 each
Jeep Exhaust Pipe
Are you tired of getting import exhaust pipes that don't fit and just aren't
as heavy as the OEM?
We were too. MWM has produced an OEM equivalent pipe in modern aluminized
tubing.
These won't rust out like the imports. Don't be fooled, the M38 and A1 pipes
are NOT the same and
we now offer both. No need to cut and weld to make it fit with these USA-made
pipes.
A1 shown. Please specify 38 or A1 when ordering. $90.00 each.
M38 & A1 Crankshaft Pulley
We made these from an original Willy's Overland print.
These look just like the original but are made from solid stock.
Don't confuse these with the cast ones. Fix your bent or broken pulley with
this premium quality one.
$125.00 each.
Jeep Generator Pulley
Fits M38 or 38A1.
These have become hard to find in recent times so we had new ones cast and
machined.
$47.00
Pulley Guard
A new, quality reproduction pulley guard is now available.
Almost always damaged or missing on project Jeeps.
Fits all Jeep 4 cyl. applications
$29.00
24V M-Series Headlamp
Tired of getting headlamp bulbs with the wrong connectors for your truck?
We have fresh, USA-made bulbs with the correct metal shells for your early
M-series truck.
We can also supply it in rubber if needed.
Metal shell type - $30.00 each
Rubber type - $26.00
M38 & 38A1 Accessary Items
MWM reproduced the clips for the top bow and passenger seat pivot chains.
Add a nice finishing detail to your restoration.
Top Bow Wing Bolts - $8.50 each
Chain & Clip Kit, (4 pcs.) - $24.00
Chains & Clips available separately also, call for details.
Clutch Cable Boot
MWM has had these reproduced to exact OEM standards.
You can now get the right part for the application instead of an imitation.
$17.50
M38A1 Upper Door Hinges
Left hand is NOS, right hand is a MWM reproduction.
Now you can finally put your door frames on your jeep.
$25.00/pair or $14.00 each.
MP50 Antenna Bracket
USA quality reproduction by MWM. Correctly stamped MP50.
Corner brackets are NOS. Fits all WWII Jeeps and Dodges.
Also correct for M38 and 38A1 Jeeps.
MP50 - $40.00
Corner Kit - $32.00
Transfer Case Shift Lever Bolt
This exclusive part to these two jeeps has not been been made available
for years.
We reproduced this part to exact tolerances. Get yours today for only $25.00.
Steering Column Clamps and Seals
The Steering column seal clamps are almost always damaged or missing.
We've sold all of our used and originals, so we reproduced these parts to
aid in your restoration.
Clamp set - $10.50
Seal - $5.50
M38 & A1 Steering Column Jacket
Exact reproduction from MWM. Includes upper column bearing.
Tube & Upper Bearing Assembly - $40.00
Bearing separately - $17.50 each
Jeep Steering Gear Worm Bearing Kit
Currently available bearing kits were not made properly and don't fit.
These accurately-produced worm gear bearings will now allow you to
properly rebuild your gear box, and tighten up your steering.
Correct for all jeeps, Civilian and Military.
$26.00
Government Rebuilt Steering Gear
We just found these never-before-available steering gears.
Correct for the M38A1 only.
GET YOURS BEFORE THEY ARE GONE!
$380.00/exchange.
Rear Frame Crossmember Kit
We've improved this part to make it more accurate. Now, the only crossmember
available with the inside support insert and the pintle hook tie plates.
Correct flat head rivets also included for proper attachment.
Kit price - $115.00.
Insert alone - $30.00.
Fuel Filter Assembly
Correct for M38 and M38 A1.
You can purchase just the element or the whole assembly.
Previously not available, get your NOS unit before they're gone.
Element: $38.00 each
Assembly: $55.00
Left Rear Splash Panel
This MWM repro pan protects the trailer socket and left rear taillight.
$18.00
Motor Mounts
Looking for the best motor mount money can buy?
Here it is. Just like OEM, plated and labeled.
Show off your jeep by detailing your restoration with these.
$17.00 each.
Fuel Tank Well
MWM has reproduced the always-rusted-out tank well.
Exact fit and as close to OEM as we could get. Correct metal gauge and ribbing.
Slight twist in part will come out at time of installation. These are the
best on the market.
$125.00 each.
Spare Tire Mount
MWM has reproduced an accurate spare tire mount for your M38A1,
Don't be fooled by the other imitators.
We have now improved this item by adding the correct spacers and the reflector
retainer.
$125.00