16075 Highway 13 S., Prior Lake, Minnesota 55372 Phone: (952) 440-8778 or FAX (952) 440-8776
PARTS HOMEPAGE VEHICLES
FOR SALE E-MAIL
JOHN 
M38 Spare Tire Carrier
We have reproduced to OEM standards the lower support portion of the spare
tire carrier. New repro upper in combination or available separately.
$98.00 for the assembly.
Lower - $64.00
Upper - $35.00
M-Series Brake Light Switch
NOS metal shell brake light switch. Limited quantity available.
Trying to do an accurate, premium restoration? You will need this!
$75.00 each.
M38 & A1 Horn Switch Adaptor
We just finished running this part. There is always damage from rust
on the threads and guide tube.
Correct fit and function for your project. Press fit into the bottom of
the steering gear.
$24 ea.
M38 & A1 Crankshaft Pulley
We made these from an original Willy's Overland print.
These look just like the original but are made from solid stock.
Don't confuse these with the cast ones. Fix your bent or broken pulley with
this premium quality one.
$125.00 each.
Pulley Guard
A new quality reproduction pulley guard is now available through MWM.
Almost always damaged or missing on project Jeeps. Fits all Jeep 4 cyl.
applications.
$29.00
Taillight Bracket
Correct for the M38 or A1. A weld-in part that was not previously available.
Commonly rusted out or damaged, now you can easily fix the problem.
$14.00 each
M-Series Full Red Lens
Finally available again, the Gama Goat red lens.
These will fit all the Early M-Series round taillight housings. Safer than
the original small red lens, but still Military.
$24.00 each.
M38 Windshield Cowl Rubber
Finally, the wait is over ... an exact fit ... properly molded weather strip
that
will allow your windshield to close properly. Every detail is the same as
OEM.
Satisfaction 100% guaranteed!
$49.50 each.
Voltmeter - M-Series
Correct for any M-series truck or jeep. Correct Douglas metal shell for
the early trucks.
This can replace the Ammeter with a 5-wire spider harness, (aslo in stock).
If you are running a Solid State voltage regulator, you must use this gauge.
$80.00 each.
Wing Drain Cover Kit
We made these correctly for all M38's and 38A1's. The screws have not
been around for years.
All items available separately also.
Kit Price (2 Wing Drains & 2 Screws) - $20.00
1 Wing Drain with 1 Seal & 2 Rivets - 8.00
Screws - $3.00 each
Jeep Exhaust Pipe
Are you tired of getting import exhaust pipes that don't fit and just aren't
as heavy as the OEM?
We were too. MWM has produced an OEM equivalent pipe in modern aluminized
tubing.
These won't rust out like the imports. Don't be fooled, the M38 and A1 pipes
are NOT the same and
we now offer both. No need to cut and weld to make it fit with these USA-made
pipes.
A1 shown. Please specify 38 or A1 when ordering. $90.00 each.
Jeep Generator Pulley
Fits M38 or 38A1.
These have become hard to find in recent times so we had new ones cast and
machined.
$47.00
M38 Floor Pans
Are you as tired of getting parts that don't fit as I am?
We took matters into our own hands. We produced an accurate replacement
floor pan for the M38.
All the correct holes, weld nuts and details. Pre-punched holes for plug
welding have already been added.
We will be adding hat channel kits very soon.
Floor Plates - $90.00 each.
24V M-Series Headlamp
Tired of getting headlamp bulbs with the wrong connectors for your truck?
We have fresh, USA-made bulbs with the correct metal shells for your early
M-series truck.
We can also supply it in rubber if needed.
Metal shell type - $30.00 each
Rubber type - $26.00
MP50 Antenna Bracket
USA quality reproduction by MWM. Correctly stamped MP50.
Corner brackets are NOS. Fits all WWII Jeeps and Dodges.
Also correct for M38 and 38A1 Jeeps.
MP50 - $40.00
Corner Kit - $32.00
M38 & 38A1 Accessary Items
MWM reproduced the clips for the top bow and passenger seat pivot chains.
Add a nice finishing detail to your restoration.
Top Bow Wing Bolts - $8.50 each
Chain & Clip Kit, (4 pcs.) - $24.00
Chains & Clips available separately also, call for details.
M38 Windshield Pivot Brackets
NOS brackets, reproduction bolts.
Other repro brackets aren't made correctly and don't have the detail of
NOS.
Get these rare parts while supplies last.
Brackets - $18.00 each.
Bolts - $6.00 each.
Rear Bow Brackets
Looking for the best quality bow brackets?
Look no further. USA-mdae by MWM.
M38 shown. M38A1 also available.
$15.00 each.
Transfer Case Shift Lever Bolt
This exclusive part to these two jeeps has not been been made available
for years.
We reproduced this part to exact tolerances. Get yours today for only $25.00.
Brake Master Cylinder Heat Shield
Accurately reproduced by MWM for proper fit and function.
M38 shown, A1 also available.
$40.00
M38 Bumper Filler
Correctly made from white oak. Easy installation.
$30.00
M38 RH Bow Bracket
This is the bracket that goes on the RH center bow bracket.
Used for anti-rattle of spare wheel when mounted on the right hand side
of the jeep.
Part #7697437 Only one required per jeep.
$9.00
Steering Gear Worm Bearing Kit
Currently available bearing kits are not made properly and don't fit.
These accurately-produced worm gear bearings will now allow you to
properly rebuild your gear box and tighten up your steering.
Correct for all jeeps, Civilian and Military.
$26.00
Clutch Cable Boot
MWM has had these reproduced to exact OEM standards.
You can now get the right part for the application instead of an imitation.
$17.50
Fuel Filter Assembly
Correct for M38 and M38 A1.
You can purchase just the element or the whole assembly.
Previously not available, get your NOS unit before they're gone.
Element: $35.00
Assembly: $55.00
M38 Front Battery Box
MWM has the most accurate reproduction available of the underhood battery
box.
You get a complete setup. Box, lower tray, retainer frame, J-bolts, angle
braces and the correct decal.
A coat of paint, and you won't know this from NOS. Pieces also sold separately.
$235.00 complete set.
Cowl Battery Box
Exactly made to fit properly in your jeep. All holes are in place.
Die-stamped bottom cover.
Box with Bottom - $110.00
Bottom Cover available separately at $34.00.
Battery Retainers
Get these always-missing parts replaced with a MWM repro.
As good as OEM. Specify 38 or A1.
Retainers - $24.00 each.
J-Bolts - $7.00 each.
Jeep Battery Tray
MWM has invested in the tooling to accurately reproduce this much needed
part.
Now available, an M38 and M38 A1 style tray for your Jeep.
Ours, pictured, looks like NOS!
Price - $70.00 each
Steering Column Clamps and Seals
The Steering column seal clamps are almost always damaged or missing.
We've sold all of our used and originals, so we reproduced these parts to
aid in your restoration.
Clamp set - $10.50
Seal - $5.50
M38 & A1 Steering Column Jacket
Exact reproduction from MWM. Includes upper column bearing.
Tube & Upper Bearing Assembly - $40.00
Bearing separately - $17.50 each
Rear Frame Crossmember Kit
We've improved this part to make it more accurate. Now, the only crossmember
available with the inside support insert and the pintle hook tie plates.
Correct flat head rivets also included for proper attachment.
Kit price - $115.00.
Insert alone - $30.00.